Airspacelink advert

EASA issues guidance for the design verification of drones operating in higher risk domains

The European Union Aviation Safety Agency (EASA) has published guidance for drone operators, manufacturers and national authorities explaining the process for the design verification of drones, an important element in ensuring safe drone operations in the ‘specific category’.

According to the EASA press release, since the new EU drone regulation became applicable on December 31, 2020, the volume of drone operations taking place across Europe has been stepped up. Operators are also gradually increasing the scope of their operations and the design verification of the drone by EASA is an important element to ensure safety, in particular when operations are conducted in populated areas.

The process applied for the design verification will depend on the level of risk of the operation. When the drone is used in operations classified as high risk (i.e. SAIL V and VI according to SORA), EASA will issue a type certificate according to Part 21 (Regulation (EU) 748/2012). When the drone is used in operations classified in the classified in the medium risk (i.e. SAIL III and IV according to SORA), a more proportionate approach will be applied, leading to a ‘design verification report’. The procedure to apply to EASA for the issuance of the ‘design verification report’ are described in the Guidelines.

“EASA continues its efforts to ensure safe, secure and sustainable operations of drones,” EASA Executive Director Patrick Ky said. “This new design verification process was developed to support all stakeholders, applying a proportionate approach which will foster innovation and growth in this promising sector”.

The design verification process is immediately applicable and national aviation authorities are encouraged to require all UAS operators who are conducting operations in the ‘specific’ category, with medium risk, to operate drones for which EASA has issued a ‘design verification report’.

A web streaming event is planned to take place on 7 May 2021 to explain the process and to answer questions.

For more information visit:

www.easa.europa.eu

 

Share this:
Rheinmetall advert